FERROLI P7 PDF

FERROLI WFL4+P7 PELLET ΤΑΞΙΑΡΩΝ. By – Ποιότητα & Οικονομία · Updated about 5 years ago · Taken in περιστερι · Already tagged. Gorilec na pelete Ferroli z visokim učinkom in omejenimi emisijami za kotle na trda goriva razreda 3 EN , zanesljiv, enostaven za uporabo in vzdrževanje.

Author: Meztibei Kelkree
Country: Tunisia
Language: English (Spanish)
Genre: Art
Published (Last): 25 June 2007
Pages: 134
PDF File Size: 18.33 Mb
ePub File Size: 14.73 Mb
ISBN: 433-5-95670-178-3
Downloads: 53245
Price: Free* [*Free Regsitration Required]
Uploader: Tygojin

This burner is very sensible and it is very hard to set properly even one power level. I have been having problems with the sun p7 for years. Unfortunately I have the problem that I thus invite a buffer and the calculated charging time fefroli be approximately two hours.

I am satisfied with ferrooli, but there are two things that I would like to ask You: I have the same installation with the same burner. Also, buy some high quality pellets a sack or two and see if the problem dissapears.

BRULEUR a Pellet FERROLI Sun P7

Me again udo spune, ferrooi I tried olive cores. I have no experience with modulating the power. Beside the fact that t04 is used only on startup not the problem in my casethis small bridges that you mention, could cause the problem.

And, even stranger, at the slightest movement the pellets that were jammed on the tube would start to fall down in the grille, sometimes while I was opening the door. Or the motor of the fan? When it start modulatioin, ferrolo just start the fan of burner and nothing else. When we had our wood burning boiler it was murder when the wind was blowing, the garage was forever filled with smoke and the Vedetta has cured this problem, and now with the new Ferroli the house is toasty warm.

  HFBR 2521 PDF

Ovviamente se hai dei consigli da comunicare ti prego di farlo. Yes, I also found out the ferrlli way that this burner only likes top quality pellets. Hello, I have problem with my ferroli sun p7. For power level 3, t12 and t13 are used to control the fan t12 and the amount of pellets t Any feedback is appreciated.

BTW how you aded me on skype. I run the SUN P7 with the parameters: In this way it detects, indirectly, the blockage. Immediately after ignition the burner would start to load more pellets, trying to reach a normal working cycle.

Stuck SUN P7 pellet burner – how to fix. – Jurnal

For the smoke problem see answer given to Safari. Hi Safari, great to hear all is good. Usually the burner starts when the thermostat orders it if u03 is 0 or according to a weekly schedule if u03 is 1 or 2.

My system is similar to this one: I have a problem since yesterday with my Sun P7.

  CERVICOFACIAL NECROTIZING FASCIITIS PDF

FERROLI WFL4+P7 PELLET ΤΑΞΙΑΡΩΝ

And what if ;7 increase power level to 2?? Have a great day, and thanks. At this moment the burner would think that the fire went out not enough pellets in the grille?

The problem is on the start ,i reduced the t04 so the the pellet dont stuck anymore ,but there is still a problem on start ,so after it load a pelet it stay some minutes and than A02 apear. Pellets size ferrolii according to the manual Wish You all the best! Just one thing i checked today is the exaust gases temperature.

What can be done? The problem is that sand will not generate any heat and chunks of glass will form in the grille so that you have to clean it more often the fan will blow away any ash but not the chunks of glass.